This is the second of my X-carve tool and accessory holders and is a modification of the one published by Julien Hoffmeyer. 3/4" MDF and I used a 1/4" round over bit in the router table to finish the top edge
70
1042
2
587
COMMENTS
These are fantastic, I've carved all three pieces. They fit perfectly in my dedicated X-Carve drawer. Thanks for sharing!
COMMENTS
These are fantastic, I've carved all three pieces. They fit perfectly in my dedicated X-Carve drawer. Thanks for sharing!
Matt Slaga · May 19, 2018
Carved #1 trying to Carve #2. will not move on to confirm bit? an you suggest something I might be doing wrong?
Keith Lake · July 02, 2020