We’re excited to announce several upgrades to our measurement input controls.
- Addition and subtraction of measurement terms
- Improved fraction support
- More units and formatting options
The goal is to more naturally support how we write measurements and lengths. To give a sense of what’s possible, all of the following are valid input expressions for 2 ¾ inches.
- 2 3/4"
- 2.75in
- 11/4"
- 3 inches - 1/4 inch
- 1 1/4" + 1.5 in
- 2+3/4"
- 0'2 3/4"
- 0ft 2.75in
- 25.4mm + 1.75in
- 2.54cm + 1 3/4"
- 1' - 9 1/4"
Most inputs in Easel and Cabinetmaker have been updated to support these new features. Although, there are a few stragglers that you may run into. We plan to finish migrating the remaining inputs in the near term.