Deer cameo
Project by
Cam Rempel
Published On
August 06, 2017
General Information
Playing with the settings on a 1/8"end mill. 36 minutes to carve out and looked so cool I tried a couple different finishes. The black one was painted before engraving. 13 1/2"x 9"
Open in Easel®
Hey Cam: Unfortunately the file that you uploaded does not seem to be the Deer Cameo that you show. When I try to open in Easel, the file is named vcarve.nc and shows circles not the images shown. Just an FYI. THANKS Mark
Mark Cooper · December 17, 2018
Ya, you are right ... The wrong file was uploaded. Now that I have a few months experience with this I can recreate it easily and have speed it up ... If any one is interested let me know and I will upload a better cleaner (right) file
Cam Rempel · December 17, 2018
Hi I would appreciate it if you could upload a better file. Thanks
Peter O'Hagan · April 10, 2019