x carve bit storage
Project by
Phillip lunsford
Published On
April 30, 2019
General Information
By popular request I am sharing this file with the community. This bit storage tray has worked very well for me. I hope you enjoy the project.
Preview in Easel
ONCE AGAIN! THANK YOU!
Fabio dos Santos · September 27, 2021
Good morning i am very new to cnc and your videos are spot on teaching me the do's and don't but learning the right bits are very confusing in this project you stated 0.120 what ecactly is that , any help with bits would be greatly appreciated sincerly angela
marie jordan · October 22, 2021
Very nice. Brand new and wanting to try this when my machine arrives. Are you OK with me using this design??
Bill · March 18, 2022
so for the wording under each. Did you just laser engrave that?
Jim Stephens · March 17, 2024
The letters were cut on the CNC then painted and sanded off the excess paint
Phillip lunsford · March 18, 2024