Maple BBQ Grill Scraper

Published Jun 28, 2018

Description

This design is for Maple BBQ Grill Scraper, replacing the wire bristle scrapers. Made from 3/4" hard maple with an additional brace handle so both hands can add pressure to the scraper. The use of Easel allows for so much customization but one hour only allows for so much!

10 Favorites

122 Views

0 Comments

89 Copies

Specs

Material: Hard Maple

Instructions

Adding the brace

After the grill scraper has finished on the X-Carve, give a light sanding to the brace part, as well as the mortise on the scraper. Apply wood glue to the tenon of brace and fit into the mortise. Allow to dry sufficiently. While drying, heat up the grill and get ready to BBQ!

Estimated time: 10 minutes

Remakes

by Mekerri Ali

by EDWARD BLACK