Night Stand Charging Station
Project by
Dallas Powers
Published On
December 04, 2015
General Information
A night stand charging station I made out of padauk and walnut.
Open in Easel®
1
Design cut outs in easel
I measured each of the items I was looking to cut into the stand and then designed that cutout in easel. If you want to remake this you will obviously have to adjust it to match your equipment.
2
routing and finishing
I routered the edge to give it a nice finish and then sealed the stand with a poly finish
Is that a wireless charger for your phone?
Michael Wilcox · April 13, 2016
yes
Dallas Powers · April 13, 2016
what kind is it and where did you get it
Michael Wilcox · April 30, 2016
did you epoxy the charging base for the watch?
RANDALL WHITEHEAD · February 10, 2018