Apple watch sport charging stand - stand part
Project by
joel yarmon
Published On
August 20, 2015
General Information
The vertical stand the apple watch charger slots into. I used corian and a heat gun to bend it backwards to allow the watch band to 'drape' over the front of the stand as the watch face is held in place by the magnetic charger.
Open in Easel®
1
Carve out the base
with carvey!
2
Carve out the stand
with carvey!
3
Bend the stand using a plastic heat bender or heat gun
careful not to burn yourself
4
Sand the edges smooth
use 200 grit or higher
Log in to post a comment to the designer